MS Gloof hoof glue MDI free, 210 ml

MS Gloof is a orange hoof adhesive for cattle in order to glue wooden or rubber blocks under the hoof. MS Gloof is the very perfect adhesive for professional hoof care due to its extremely fast-drying action

MS Gloof hoof glue MDI-free is a hoof glue without methylene diphenyl diisocyanate (MDI), a substance known for potential health issues such as skin irritation, respiratory problems, and allergic reactions.

Please note: Only use the MS Gloof in combination with the hoof adhesive dosing gun, 210 ml.

• Quick-drying adhesive
• Bonds strongly
• Drying time of roughly 90 seconds
• Characteristic colour that makes it easy to recognise in practice
• The components are mixed in the proper proportions in the mixing tip
• No unpleasant odour

• Shake before use
• Gluing hoof blocks to cattle hooves
• For best results, hoof must be clean and dry.
• Do not preheat the claw or hoof block (store hoof blocks dry and without condensation, preferably at around 20 degrees; claws should be clean and dry but not pre-burned or pretreated with a dryer).
• Apply glue to the claw (not to the hoof block: doing so makes you too slow) and gently press the claw block onto the claw within 10 seconds. If you go slower, there's a risk that the glue will already have formed a skin, which will significantly reduce its strength.
• Wait at least 1.5–2 minutes before putting weight on the claw. Check whether the glue on the side of the hoof block is glass-hard and no longer rubbery.

• In order to prevent the tip from getting stuck after use, the tip must be loosened a quarter turn after being screwed on.
• Generates very little heat when setting
• The components are mixed in the proper ratio in the mixing tip
• No unpleasant odour

• Step 1: Store the tube upright and hold the tube upright when opening
• Step 2: Open the tube or replace the mixer tip
• Step 3: Press the glue slowly until the mixer tip is filled halfway, with the tip pointing upward. The remaining air will move away from the tube
• Step 4: Slowly apply the glue in a fluid pump movement to the claw
• Step 5: When you're done, please keep the tube with the tip down and relieve pressure from the gun to stop further flowing. After 10 seconds the gun can be put down flat. This prevents backflow of pre-mixed glue into the tube
• Step 6: At the next gluing, the tube does not contain air anymore and therefore you can proceed to step 3.