MS Digi Doser Duo General 2

The Digi Doser Duo General 2 is a dosing system that can deliver doses of both Di-O-Clean and additives, simultaneously and independently of each other. The system is equipped with 2 digital diaphragm pumps, which dispenses the right amount of each product in the water pipe, based on pulses from a water meter.

The Digi Doser is delivered in plug & play modules. These modules are easy to mount on the stainless steel back plate, by using the included instruction card.

• A simple system for dosing Di-O-Clean and additives
• Equipped with a float system with warning when empty
• Specially designed to provide low dosage in an accurate manner
• Made out of special chlorine dioxide and additives resistant materials
• The correct pressure is a requirement for the proper function of the dosing system. You must also install a water filter and pressure regulator for this

• Mount the pump as close as possible after entering the source and tap water. In this way, the entire drinking water system can be cleaned and disinfected as completely as possible
• Create a by-pass, so the drinking water system can also be used during an defect or malfunction at any time
• If the supply water contains (a little) dirt, install a water filter in front of the dosing system. This will avert water meter faults
• In case of doubt about the flow capacity, water pressure or dosage, our employees are ready to advise you
• Upon startup or replacement of parts, the Digi Doser must be calibrated

• Throughput capacity: 15 - 2,500 l/hour
• Water pressure: 0.05 - 3 bar
• Dosage: Di-O-Clean: 1 – 1080 ppm / Standard: 0,1 – 1% at a maximum of 2.500 L/hour water flow / Optional: 0,1 – 2% at a maximum of 1.250 L/hour water flow / Optional: 0,1 – 3% at a maximum of 850 L/hour water flow
• Max. pump capacity: Di-O-Clean: 2.7 l/hour / Max. pump capacity: 30 l/hour
• Water meter pulses: 2 p/litre
• Input and output connections: PVC 40 mm – 40 mm