Suevia Thermocable 230V, 18 m

The thermocable prevents drinking water pipes and supply pipes from freezing.

The thermocable is available in various measurements

• Prevents freezing in water pipes up to 1”
• Built-in thermostat
• Automatic regulation
• Operating range: 3 - 10 °C
• Does not use power in standby mode
• Includes connector cable and plug

• The cable is secured parallel to the underside of the pipe.
• The thermostat is located at the end of the thermocable and must be installed at the coldest location.
• Any potential remaining length must be wrapped around the pipe
• It is recommended that the wiring for the thermocable and thermostat be insulated
• A ground-fault circuit interrupter is required

• The thermostat will turn itself off once the temperature has exceeded 10 degrees and will turn itself back on when the temperature drops below 3 degrees
• If in the reach of animals, the thermocable must be protected against damage
• The thermocable must not be clipped
• If the cable is mounted to a plastic pipe, please make sure that the pipe is suitable for both cold and warm water.
• For better distribution, the plastic pipe must be wrapped in aluminium tape before the thermocable is mounted

Voltage: 230 Volt

• The thermocable is provided with a connector cable (2m) and a 230V plug
• VDE certified